Hi
I just built my teststand sequence and it failed due to a broken VI. On inspection my sequence should not be calling this close.vi at all (Its closing a piece I equipment I am not using in this sequence). So does any one know how to find why it appears when I insert code modules?
I have tried finding callers of the VI, run sequence documentation... with no luck. Tried to find it will a mass compile... Call hierechy in the delopyment utility says its dependent on my sequence file. I have performed a find on sequence file and not found it.
I have fixed the VI so I can move on, but I would still like to remove "dead" VI's from the installer. Any suggestions?