Is there a way to isolate different channels of an RF multiplexer using Autoscheduling? I have one channel of the multiplexer tied to my signal generator and one channel tied to the signal analyzer. When I put the "Set RF Channel"(connecting the multiplexer to UUT) test step into the autoschedule "Tune Tx Output" it's locking the multiplexer resouce from being used in the "measure Rx Sensitivity" autoschedule step.
Is there a way around this? I would like to lock access to a particular channel on the multiplexer, but still have the ability to control two channels using different autoschedule steps.
Thanks in advance for any ideas you have!